Mercury ELITE 1000 PRO UPS
| Input Voltage | 220VAC |
| Input Frequency | 50Hz |
| Input Phase | Single Phase |
| Input Socket | with FUSE |
| Cold Start (0~100% load) | Press the ON / OFF Switch |
| Input Range (220V) | 140V~285V |
| Normal Frequency | 50Hz |
| Rating Output (VA) | 1000VA |
| Rating Output (W) | 600W |
| Waveform | Battery Mode (Simulated Sine Wave) AC Mode (Sine Wave) |
| Power Factor | 0.6 |
| Rating Voltage | 220V |
| Output Range | 220VAC +17~22% (No Load Connected) |
| Rear Output Socket | 3x IEC - Battery Backup |
| Transfer Time | Typical 8ms (max 15ms) |
| Short Circuit Protection Line Mode | FUSE & Software Protection 100%~120% (gives alarm & shut down in 3min) 120%~130% (beeps alarm & shut down in 30s) >130% (shut down immediately) |
| Battery Mode | Software Protection controlled by CPU 100%~110% (gives alarm & shut down in 10s) >110% (shut down immediately) |
| Battery & Runtime Rating | 12V / 9AH x1 |
| Battery & Runtime Backup Time | Typical 8mins~20mins |
| Battery & Runtime Change Current | 1.5A (max) |
| Battery & Runtime Over Charge | >14.8V ±0.5 (Stop Charging) |
| Battery & Runtime Protection | <13.5V ±0.5 (Recharge) |
| Weight (kg) | 7.5 |
| Dimension (mm) | 370 x 145 x 230 |
| Master Carton (mm) | 393 x 310 x 267 (2pcs) |
| Output Rating Frequency | 50Hz |
| Output Line Mode | Synchronize with the Utility |
| Output Battery Mode | 50Hz ±1Hz |
Mercury Elite 2000 Pro UPS
| Rating input voltage | 2000 VA / 1200 W |
| Rating input frequency | 60/50Hz (auto sensing) |
| Input phase | Single phase |
| Input socket | With Fuse |
| Cold Start (0 to 100% load) | Press the ON/OFF Switch |
| Input Range (220V) | 140-300 |
| Rating output(VA) | 2000 |
| Rating output (W) | 1200 |
| Power factor | 0.6 |
| Rating output voltage (V) | 220 |
| Waveform | Battery mode (simulated sine wave), AC mode(sine wave) |
| AC Voltage Regulation | ±10% (Battery mode) |
| Rear output socket | 4 x Universal - Battery backup |
| Waveform | Simulated Sine Wave (Battery mode) |
| Line Mode | Synchronize with the utility |
| Rating frequency | 60Hz or 50 Hz ± 1 Hz |
| Battery Mode | Yellow flashing |
| Short circuit protection Line Mode | Fuse & Firmware protection |
| Short circuit protection Battery Mode | Firmware Protection |
| Overload protection Line Mode | 110%±5%; Go to fault mode Line Mode after 5 minutes, 120%±5%; Go to fault mode immediately. |
| Overload protection Battery Mode | 110%±5%; Shutdown after 5 seconds, 120%±5%, Shutdown immediately |
| Indicators AC mode | Green Lighting |
| Indicators Battery Mode | Yellow Flashing |
| Indicators Fault | Red Lighting |
| Alarm Battery Mode | Sounding every 10 Seconds |
| Alarm Low Battery | Sounding every Second |
| Alarm Overload | Sounding every 0.5 second |
| Alarm Fault | Continuously sounding |
| Full Protection | Overload, discharge, and Overcharge protection |
| Transfer Time | Typical 2-6ms, 10ms max. |
| Transfer Time | Typical 2-6ms, 10ms max. |
| Communication Interface | Optional RS232/RJ11 |
| Battery and runtime Rating | 2 X 12V/9AH |
| Recharge time - Typical | 6-8 hours recover to 90% capacity |
| Charge current | About 1A at normal mode. |
| Dimension, W X H X D (cm) | 22.5 X 12.5 X 39 |
| Net Weight (kgs) | 12.7KGS |
| Humidity | 0-90 % RH @ 0- 40°C (non-condensing) |
| Noise Level | Less than 45dB |
| Compatible with OS | Supports Windows® 2000/2003/XP/Vista/2008/7 |
| Communication interface | Elite 2000pro (N/A), Elite 2000ipro (USB/RJ11) |
Mercury ELITE 650 PRO Line UPS
| Input voltage | 220VAC |
| Input frequency | 50Hz |
| Input phase | Single phase |
| Input socket | With Fuse |
| Cold Start (0 to 100% load) | Press the ON/OFF switch |
| Input range (220V) | 140V-300V |
| Rating output (VA). | 650VA |
| Rating output (W). | 390W |
| Rating output (W). | Battery mode(simulated sine wave), AC mode (sine wave) |
| Power factor | 0.6 |
| Rating voltage | 220V |
| Output range | 220Vac-7%+15% ( in battary mode ) |
| Rear Output Socket | 2xUniversal - Battery backup |
| Transfer time | TYPICAL 4-8 ms |
| Communication Interface | NIL |
| Rating frequency | 50Hz |
| Output Frequency Line-mode | Synchronize with the Utility |
| Battery mode | 50 Hz±1Hz |
| Output Frequency Line Mode | Synchronize with the utility |
| Short Circuit Protection Line Mode | FUSE & firmware protection |
| Battery Mode | Software protection controlled by firmware |
| Overload Protection Line Mode | 110%+-5% (Go to fault mode after 5 minutes), 120%+-5% (Go to fault mode immediately) |
| Battery Mode | 110%+-5% (Shutdown after 5 minutes) 120%+-5% (Shut down immediately) |
| Rating frequency | 12V/8.2AH x 1 |
| Backup Tim - Typical | 10mins to 18mins (depending on load) |
| Charge Current | About 1A at normal mode |
| Over Charge Protection | >14.5V +/- 0.2V stop charging <13.5V +/- 0.5V Recharge |
| Weight | 5.6kg +/- 0.3Kg |
| Dimension | 390x 145 x 220 (mm) |
| Master Carton | 45.5 x 40 x 23.5 (cm) (4pcs) |
Mercury ELITE 850 PRO Line UPS
| Input | . |
| Input Voltage | 220VAC |
| Input Frequency | 50Hz |
| Input Phase | Single phase |
| PowerCord | Built-in Cable with Fuse |
| Input Voltage Range | 140~300VAC |
| Output | . |
| Rating Output | 850VA |
| Wave Form | Battery Mode (Simulated Sine Wave) AC Mode (Synchronize with Input) |
| Rating Voltage | 220V |
| Output Range | 220VAC-11% to +17% (Battery Mode) |
| Rear Output Socket | 2xUniversal-Battery Backup |
| Transfer Time | Typical 4-8ms |
| Communication Interface | Nil |
| Output Frequency | . |
| Rating Frequency | 50Hz |
| Line Mode | Synchronize with the Utility |
| Battery Mode | 50Hz±1Hz |
| Short Circuit Protection | . |
| Line Mode | Fuse & Firmware Protection |
| Battery Mode | Firmware Protection |
| Overload Protection | . |
| Line Mode | 110%±5% (go to fault mode after 5 minutes) 120%±5% (go to fault mode immediately) |
| Battery Mode | 85%±5% (Shut down after 5 seconds) 100%±5% (shut down immediately) |
| Battery and Runtime | . |
| Rating | 1x12V/9AH |
| Backup Time - Typical | 15mins~25mins (Depending On Load) |
| Charging Current | About 1A at Normal Mode |
| OverCharge Protection | 14.5V±0.2V(Stop Charging) <13.5V±0.5V(Recharge) |
| Packaging | . |
| Dimension(mm) | 350x142x213 |
| Master Carton(mm) | 365x304x446 |
| Packsize per Master Carton(mm) | 2 |
Mercury Elite1500 Pro UPS
| Input | . |
| Input Voltage | 220VAC |
| Input Frequency | 50Hz |
| Input Phase | Single Phase |
| PowerCord | Built-in Cable with Fuse |
| Input Voltage Range(May vary as per Country requirement) | 140~300VAC |
| Output | . |
| Rating Output | 1500VA |
| Wave Form | Battery Mode (Simulated sine Wave) AC Mode (Synchronize with Input) |
| Rating Voltage | 220V |
| Output Range | 220VAC - 11% to + 17% (Battery Mode) |
| Rear Output Socket | 4x Universal - Battery Backup |
| Transfer Time | Typical 4-8ms |
| Communication Interface | Nil |
| Output Frequency | . |
| Rating Frequency | 50Hz |
| Line Mode | Synchronize with the Utility |
| Battery Mode | 50Hz±1Hz |
| Short Circuit Protection | . |
| Line Mode | FUSE & Firmware Protection |
| Battery Mode | Firmware Protection |
| Overload Protection | . |
| Line Mode | 110%±5% (go to fault mode after 5 minutes) 120%±5% (go to fault mode immediately) |
| Battery Mode | 85%±5% (shut down after 5 seconds) 100%±5% (shut down immediately) |
| Battery and Runtime | . |
| Rating | 2x12V/8.2AH |
| Backup Time - Typical | 30mins~40mins (Depending On Load) |
| Charging Current | About 1A at Normal Mode |
| OverCharge Protection | 29V±0.2V(Stop Charging) <27V ±0.5V(Recharge) |
| Packaging | . |
| Dimension(mm) | 388x203x260 |
| Master Carton(mm) | 425x403x280 |
| Packsize per Master Carton(mm) | 2 |
TP-LINK TL-WN781ND PCI Express Wireless
